Hi,
If I try to /sbin/modprobe usb-ehci, all I get is module ehci_usb cannot be found. Is anyone else seeing that?
Also, I have a new floppy drive which has in it an SD reader and other card readers. This is picked up as it's connected to one of the USB plugs on the motherboard.
There is power to it, but both /sbin/lsusb is showing nothing and kudzu didn't see anything.
The drive itself (specs etc) can be seen at
http://www.dabs.com/uk/channels/hardware/storage/productView.htm? quicklinx=2SRJ
As usual, the manufacturers website is brain-dead enough to say their site is "optimised" for IE (what ever the heck that means - I'm guessing it means it's broken!) and doesn't even mention Linux.
Does anyone know what modules I need to load for it (I have ohci and uhci as well as usb-storage loaded, but nothing seems to be found). Is it just a case of adding the devices to fstab and if so, what would they be called and where would they get mounted?
I'm using FC3T3 (though when I reboot, it is saying I'm still on T2!)
TTFN
Paul
I'm running 2.6.9-1.667 and all my USB stuff works fine. I was using a USB Serial port yesterday. (PL2303 type...) My USB hard drive works fine too.
I was worried about the USB hard drive because the system log said it was connected via USB1.1, but it still transferred data at 25MB/sec, so it must have been using USB2.0
On Sat, 2004-11-06 at 13:04 +0000, Paul wrote:
Hi,
If I try to /sbin/modprobe usb-ehci, all I get is module ehci_usb cannot be found. Is anyone else seeing that?
Also, I have a new floppy drive which has in it an SD reader and other card readers. This is picked up as it's connected to one of the USB plugs on the motherboard.
There is power to it, but both /sbin/lsusb is showing nothing and kudzu didn't see anything.
The drive itself (specs etc) can be seen at
http://www.dabs.com/uk/channels/hardware/storage/productView.htm? quicklinx=2SRJ
As usual, the manufacturers website is brain-dead enough to say their site is "optimised" for IE (what ever the heck that means - I'm guessing it means it's broken!) and doesn't even mention Linux.
Does anyone know what modules I need to load for it (I have ohci and uhci as well as usb-storage loaded, but nothing seems to be found). Is it just a case of adding the devices to fstab and if so, what would they be called and where would they get mounted?
I'm using FC3T3 (though when I reboot, it is saying I'm still on T2!)
TTFN
Paul
fedora-test-list mailing list fedora-test-list@redhat.com To unsubscribe: http://www.redhat.com/mailman/listinfo/fedora-test-list