Hello all,
I am running Fedora 8 Test 3 on an ESPRIMO 5720, When I boot from the CD it starts to load until the ACPI when I get the following:
ACPI: bus type pci registered PCI: Using MMCONFIG Setting up standard PCI resources ACPI: Interpreter enabled ACPI: (supports S0 S1 S3 S4 S5) ACPI: Using IOAPIC for interrupt routing ACPI: Device [ECP] status [00000008]: functional but not present; setting present ACPI: PCI Root Bridge [PCI0] (0000:00)
At that point the machine freezes and needs to be turned off via the power switch. I tried adding the noapci to the boot arguments but that dose not seem to help.
Anyone got any ideas about this?
Hello,
I fixed it with the boot argument "pci=nommconf"
Myerscough, Damian wrote:
Hello all,
I am running Fedora 8 Test 3 on an ESPRIMO 5720, When I boot from the CD it starts to load until the ACPI when I get the following:
ACPI: bus type pci registered PCI: Using MMCONFIG Setting up standard PCI resources ACPI: Interpreter enabled ACPI: (supports S0 S1 S3 S4 S5) ACPI: Using IOAPIC for interrupt routing ACPI: Device [ECP] status [00000008]: functional but not present; setting present ACPI: PCI Root Bridge [PCI0] (0000:00)
At that point the machine freezes and needs to be turned off via the power switch. I tried adding the noapci to the boot arguments but that dose not seem to help.
Anyone got any ideas about this?
-- Regards, Damian Myerscough
-- fedora-test-list mailing list fedora-test-list@redhat.com To unsubscribe: https://www.redhat.com/mailman/listinfo/fedora-test-list
Damian Myerscough wrote:
Hello,
I fixed it with the boot argument "pci=nommconf"
There's a bug, discussed here very recently, with (almost) this on HP DC7700p. Pls check the archive, and add a "me to" to tbe bug report.
https://bugzilla.redhat.com/show_bug.cgi?id=251493
and the thread's 7.92 install disk does not boot on HP dc7700
The HP requires "pci=nomsi,nommconf"