Where do I find the link status - 10mps, 100mps, half-duplex, duplex, etc - for a 3Com ethernet adapter in fc4.
I have two adapters on this machine, eth1 is the 3Com. dmesg shows:
....................... 8139too Fast Ethernet driver 0.9.27 eth0: RealTek RTL8139 at 0xfc00, 00:48:54:8b:ab:29, IRQ 11 eth0: Identified 8139 chip type 'RTL-8139B' 3c59x: Donald Becker and others. www.scyld.com/network/vortex.html 0000:00:0f.0: 3Com PCI 3c595 Vortex 100baseTx at 0xff80. Vers LK1.1.19 0000:00:0f.0: Overriding PCI latency timer (CFLT) setting of 64, new value is 248. .............. eth0: link up, 10Mbps, half-duplex, lpa 0x0000 .................. eth1: no IPv6 routers present eth0: no IPv6 routers present ......
ifconfig doesn't help.
???
sean
On Fri, 2005-09-30 at 13:18 -0400, sean wrote:
Where do I find the link status - 10mps, 100mps, half-duplex, duplex, etc - for a 3Com ethernet adapter in fc4.
I have two adapters on this machine, eth1 is the 3Com. dmesg shows:
....................... 8139too Fast Ethernet driver 0.9.27 eth0: RealTek RTL8139 at 0xfc00, 00:48:54:8b:ab:29, IRQ 11 eth0: Identified 8139 chip type 'RTL-8139B' 3c59x: Donald Becker and others. www.scyld.com/network/vortex.html 0000:00:0f.0: 3Com PCI 3c595 Vortex 100baseTx at 0xff80. Vers LK1.1.19 0000:00:0f.0: Overriding PCI latency timer (CFLT) setting of 64, new value is 248. .............. eth0: link up, 10Mbps, half-duplex, lpa 0x0000 .................. eth1: no IPv6 routers present eth0: no IPv6 routers present ......
ifconfig doesn't help.
???
sean
Sean,
Does mii-tool or ethtool work for this device?
Bob...
Bob Chiodini wrote:
On Fri, 2005-09-30 at 13:18 -0400, sean wrote:
Where do I find the link status - 10mps, 100mps, half-duplex, duplex, etc - for a 3Com ethernet adapter in fc4.
............
Sean,
Does mii-tool or ethtool work for this device?
Bob...
Thanks. Both do.
sean