On 3/3/07, Rick Stevens rstevens@vitalstream.com wrote:
On Fri, 2007-03-02 at 14:42 +0800, Zhen Zhou wrote:
Hi, lists, Now I dive the sea of xen, I took a Dell 2950 Server, install FC 6 i386 on it, I refer some documents about Xen: http://www.fedoraproject.org/wiki/FedoraXenQuickstartFC6 So i checked as following:
- check Intel VM for host CPU, it works, it showed me:
flags : fpu vme de pse tsc msr pae mce cx8 apic mtrr pge mca cmov pat pse36 clflush dts acpi mmx fxsr sse sse2 ss ht tm pbe nx lm constant_tsc pni monitor ds_cpl vmx tm2 cx16 xtpr lahf_lm
^^^
The "vmx" flag is the Intel virtualization flag. Middle of the third line above (I marked it).
- check hvm-??, then I have no luck. even I enable virtualization in BIOS.
Again, the flag is "vmx" for Intel, "svm" for AMD.
so how could I enable fully-virtualizied in this server? or should I install x86_64 for it? Because this server CPU is Intel Xeon Core 5130 serial.
You should have the fully virtualized ability since you have the vmx flag.
But when I want to check hypervisor capability set in this server:
# cat /sys/hypervisor/properties/capabilities :
nothing to me, so should I discare it? or the server couldn't support full virtualization capaility, even CPU is right one, is it?
Thanks a lot,
Zhou Zhen
- Rick Stevens, Principal Engineer rstevens@vitalstream.com -
- VitalStream, Inc. http://www.vitalstream.com -
-
- Silence! Or I shall replace you with a very small shell script! -
- The Wizard of OS -